HCWT1
Posts: 161
Joined: 7/7/2005 Status: offline
|
Anything is possible................ with pensil and tap,draw lines,end to end,at said distance apart,all the way around the rolling pin.Use 1/32inch drill,holes spaced along lines 7/8th inch deep.Use 1 inch finishing nails,with heads cut off,insert into holes upside down,useing small tack hammer,as not to blunt the nails.A small amount of hot glue may be needed on inner end of each nail. You should end up with the effect you seek. Maybe even better if you offset your lines, that way many lines will be in contact at the same time. Have fun.
|