CB 6000... is a VERY tight fit.. is this ok?

CB 6000... is a VERY tight fit.. is this ok? (Full Version)

All Forums >> [Community Discussions] >> Bondage Gear and Apparel

Message

fairdom23 -> CB 6000... is a VERY tight fit.. is this ok? (10/29/2010 5:27:43 PM)
I will admit this is my first chastity device, and so far it is working quite well, in terms of comfort while wearing it. however when putting it on, it is very hard to get the head inside the plastic portion, and getting the rest in is even more dificult. i have read that using silicone helps so i bought some and applied it somewhat generously to assist in sliding into the CB6000 i have had it on for about an hour now and do not feel any discomfort or the sensation it is too tight. however the overall tightness of the ring that secures the device(going behind the balls) is also fairly tight. will this slight restriction in blood flow cause any issues? ideally i would like to be able to wear this 24/7, with daily cleaning of course. basically, i am wondering if all this is normal/ok in terms of how snug it is. any advice or tips are as always, greatly appreciated. thank you.

thatsub -> RE: CB 6000... is a VERY tight fit.. is this ok? (10/29/2010 7:17:55 PM)
Ring wise you should pick the one that you can handle, if current one causes too much discomfort, then go a size up. Small rings cause way too much pain for me in a morning. And for spacers you should use the smallest one possible. Choosing the smallest one will prevent you from completely pulling off the device. As for getting yourself in, I can only suggest to be less "excited" and use more lube. Some people use nylon sock method, but I have not tried it myself.

MrKicia -> RE: CB 6000... is a VERY tight fit.. is this ok? (10/29/2010 10:11:19 PM)
nylon sock? Please elaborate.

fairdom23 -> RE: CB 6000... is a VERY tight fit.. is this ok? (10/30/2010 8:01:38 AM)
quote: ORIGINAL: thatsub Ring wise you should pick the one that you can handle, if current one causes too much discomfort, then go a size up. Small rings cause way too much pain for me in a morning. And for spacers you should use the smallest one possible. Choosing the smallest one will prevent you from completely pulling off the device. As for getting yourself in, I can only suggest to be less "excited" and use more lube. Some people use nylon sock method, but I have not tried it myself. I am using the largest ring size and after wearing it for a few hours last night, i believe it should be OK. there is no chance i will be able to slip out of this thing, as even with the longest spacer it is still a very snug fit. I will pick up some baby oil today and see if that helps. how does a nylon sock help with putting it on?

thatsub -> RE: CB 6000... is a VERY tight fit.. is this ok? (10/30/2010 1:53:37 PM)
The "sock method" works like this: Take a nylon sock. Thread the toe end through the slot in the end of the cage. Slip the open end of the nylon over the head of your penis. As you slide the cage over your penis, use the sock to pull the head of your penis into the cage. As for not slipping out, try taking a bath and fully relaxing your body - and you will see how all of the sudden that device, which was so tight just an hour ago, becomes very insecure. A lot of men can pull that cage off from their penises (the balls usually stay in though).

fairdom23 -> RE: CB 6000... is a VERY tight fit.. is this ok? (10/31/2010 8:44:25 PM)
well, it looks like i was just a bit "excited about wearing it at first, as it fits perfectly now. still not a chance of me pulling out of it, even if i wanted to. now. this is a new aspect of submission that i have to admit, I am enjoying immensely thus far.

Page: [1]

Collarchat.com © 2025

Terms of Service

0.015625