scottyh
Posts: 2
Joined: 2/5/2007 Status: offline
|
Hi.... I though people might be interested in a homemade CBT device I made the other day....... It's quite simple, but very effective. You'll need - a finished toilet roll tube, some duct tape, sand paper (optional), 10 -20 drawing pins (or thumb tacks), a stapler and a couple of zip ties. 1. First, put a single layer of duct tape over the toilet roll. 2. Now cut the toilet roll down its length so you are left with a rectangle piece of cardboard. 3. If you are using sandpaper as an optional extra, then cut the sandpaper to match the size of the rectangle and staple to the cardboard side. 4. Take the drawing pins and insert them randomly into the cardboard. Push the tacks in from the tape side of the cardboard, so the points penetrate the sandpaper. I use approx 12 tacks, the number depends largely on your own preference - and desire to cause pain. 5. Place a second layer of tape over the first layer. This is to hold the tacks tightly in place. And there you have it..... I'm sure I don't need to spell out the next part, but take the rectangle and wrap it around your (subs) penis - tacks pointing toward the penis of course :-) Then secure it with a couple of zip ties - I find one at the base and one just below the head secures it in place nicely. Personally, I get the most pleasure (and pain) out of this when I apply to my flaccid, or semi-erect penis, and pull the zip ties so its nice and snug. But not so tight that the pain is already unbearable - I'd say a 7/10 on the CBT pain scale. I'll let your own imaginations work out what to do next. Personally, I like to sit back and watch my favorite movie - and the inevitable happens. It's a fantastic mix of being teased by what I'm watching, but not wanting to get too hard because the pain becomes too intense. It's almost impossible (for me) to cum in this state. If the device is on tight, it's just too painful to masturbate. So you have to wait until you become soft again before you can remove the device. Be careful not to tighten the zip ties too tight on your first go though. Its not easy to get them off (even with scissors).... I hope people find this useful (and fun)..... scott
|