Wireless Devices

Wireless Devices (Full Version)

All Forums >> [Community Discussions] >> Bondage Gear and Apparel

Message

toptobottom -> Wireless Devices (8/30/2006 2:32:26 PM)
i am looking to design and build a wireless remote control device that can be attached to a penis and activated remotely from a control unit from perhaps 30 feet or so away, allowing the wearer to be "milked". i have looked in a few adult stores to see what might be available commerically but there really does not seem to be much out there. Was wondering if anyone has explored this subject before and might have any suggstions or advice.

formenteralady -> RE: Wireless Devices (8/30/2006 6:41:48 PM)
most of the remote control devices I've run across has to do with panty vibrators...you might have to contact a toy maker who does custom pieces inorder to get this.

rosiegurl -> RE: Wireless Devices (8/31/2006 12:31:12 AM)
this kinda thing can be built relativly easily using something like a vacuum tube, or those vibrating toys for men. all it would need is a small wireless unit attached to the power, so it could be switched on and off. the only problem I really forsee in such an item, is to get the guy to actually cum without anyother type of stimulas, I know personally, if I had one on, it would not make me cum, by itself

toptobottom -> RE: Wireless Devices (8/31/2006 2:14:58 AM)
hi rosie, thanks for your reply..Someone suggested using a couple of small wireless vibrators secured with velcro. Might work.....

QuietDom -> RE: Wireless Devices (8/31/2006 7:45:25 AM)
Yep, a device to get a man to ejaculate all by itself would have to be pretty elaborate -- probably not something that could be worn under clothes. Unless you run a pair of wires through the anus to electrodes positioned across the prostate gland. Start with a very low current and work up slowly. Very difficult to set up, but thoroughly effective if you can manage it. Oddly enough, this is how zookeepers collect sperm from bull elephants, only using cattleprods.

Irishm57 -> RE: Wireless Devices (9/2/2006 5:08:18 AM)
If you are semi electrically inclined, kits like this are great starters for home grown wireless remote control toys http://www.electronickits.com/remote_control/rf2.htm the board does need a 12 volt dc power source, but there are camera/toy batteries that are small and 12 volt and rechargable.I have made a few toys using these. A while ago i put together some wiring info for those that want to make their own. http://www.slavechris.com/Pwire.html most info on there based on what i did with a Rimba tens unit

Page: [1]

Collarchat.com © 2024

Terms of Service

0.046875