Termyn8or
Posts: 18681
Joined: 11/12/2005 Status: offline
|
I find this a bit difficult to understand, if you can stand it hamging on you all day there should not be a problem at might. One way I could imagine is if you have rather pendulous balls and sleep on your back. If there happens to be a fold or crease in your skin under the A ring this could be a problem. I have achieved a very good comfort level with the 3000 by doing these things: Went to the largest A ring. Anything smaller and I get that crease toward the bottom. This is like sticking a 3 inch hose into a 2 inch hole, it has to fold over, OUCH. Actually this could be tolerable standing and sitting, but flat on the back I bet you can feel it. In going to the large ring I decreased the gap to almost nothing. The ring is pulled in alot, that is I get as much scrotum in as possible. It varies person to person, but there is a bit of scrotun sort of at the top of the base of you penis. In my case it is substantial. So when I get in like this, pullout is impossible. In fact just getting the ring off is a bit hard and I can't just pull it out, I must push it out. I added a makeshift harness (pics available on reuest, or in other posts) which takes all the weight off of it. First and foremost is the installation, the scrotum must be in there just right or it is hell. You must work it around a bit so there is no crease or fold under the ring. Even if you have to pull most of it up, you can pull it back down once the crease is gone. Then it is a gradual compression. Now try this with a solid A ring ! , I have the upgrade. Regardless, wear the ring for a little while and maybe take a hot bath or shower. Get loose. Stretch as much of it out of there as you can, all the while feeling if there is a crease, and if there is, eliminate it. Do this by using your fingers both over and under the ring, pull up. When all the creases are gone, pull down but from tho outside only. While I am trying to be as descriptive as possible I know this is hard to visualize. IF you had the upgrade and the solid ring you might see it better. Scrotum management is a major issue for some with a solid ring, and of course that's why they came out with the split ring. Yes it makes it easier to put on, but it denies you the education of putting it on the old fashioned way. Now, a bit jokingly, but plain talk (and reall plain if ya know whata mean). Son, in my day we had to stick one ball through, pull enough sack though to get it out the fuckin way and then enough room for the other ball. Once the balls are in then we had to push our dick damnear all the way into the body to get it to go through. Then we had to fuck around for ten minutes to get everything settled in. Used to use vaseline but baby oil is alot better. (back to normal now) OK, for one, do not lube before you put the ring on, once the ring is on, use a swab and pull your scrotum slightly in and out of it, staying in it all the while of course. Lube it at that time, you expose one section of skin, then the other. Swab it up. Once you are all comfy lube the tube. Do not lube your penis, do the entire inside of the tube. Put the tube on at an angle, sidestepping the alignment and locking pins. Push it as far as it will go and get as much of you in there as possible, then feel underneath for an excess of skin, I mean the bottom of the tube. If there, shove it in the tube. you can always pull it out later. And then the first day locked is when you fine tune everything. I took mine off, actually had to get the keys back, because we are going out of town tonight. Lemme give the really plain talk about that : Look, we gonna have beer and pot and maybe even some in the car and we're going like 100 fuckin miles. Fuckit, we are going to a concert ! We are not completely stupid, I got the biggest car but I am not going to drive, the driver does not drink. I'll take care of that. Also, if I got the 3000 on, if we ride six people it will be a bit squished, or more aptly put, THEY will be squished. T More later.
|