Joseff
Posts: 505
Joined: 6/2/2007 Status: offline
|
quote:
ORIGINAL: instynctive quote:
ORIGINAL: KirstyChibiMoon wow great idea :) i took an old dildo of mine with a burnt out motor and filled up the batter compartment with epoxy... then i stuck in a bit so it canbe connected to a drill gun :) so i call it my drill-do... only problem is a slower moving screw gun would be nice *giggle* my drill gun tends to take off too fast That would work for a sawsall too... Grind down the teeth on the blade.. maybe drill some small holes along the part of the blade that would be inside the dildo, insert the makeshift shaft into the battery conpartment, fill it with epoxy and voila! DISCLAIMER: I'm not saying that will work, but it *might*... :-) Should work fairly well, especially drilling the holes. Just remember, the saw blade is made from VERY strong metal. It will be difficult to drill and not much easier to grind. If you are set up to do it, use a torch to heat the blade untill red, then allow it to cool slowly. Plungeing it into a bucket of sand or even (clean) cat litter will help. Another method, throw it on the coals of your Hibachi after you cook your steaks, and leave it there untill cold. A campfire or fireplace fire could also be used. If you use this method, don't bury the blade in the coals, as that can actually harden it. Good luck. Joseff
|